Large industrial ultrasonic cleaner 22L & 30L

Varnish deposits inside carburetor bores don't respond to spray cleaner. You soak, you scrub, you reassemble, and three weeks later the idle hunts again. The root cause never left. This 30L heated large industrial ultrasonic cleaner addresses that directly: a 600W heating system brings the bath to 80°C while 8 to 10 sandwich-type piezoelectric transducers drive 40kHz cavitation into passages a brush will never reach. Set the timer to 30 minutes and walk away.

Why you need to choose the Large industrial ultrasonic cleaner 30L?

The 40kHz transducer array generates millions of micro-bubbles that implode against metal surfaces at the microscopic level. For a small engine shop processing carburetors, fuel injectors, and throttle bodies in the same session, this means contaminants are dislodged from blind passages without disassembly beyond what you already do for inspection. The 22L model handles a full carburetor set comfortably; the 30L accepts intake manifold components that would never fit a compact unit.

Temperature matters more than most shop owners expect. At 60°C, petroleum-based varnish softens and releases from aluminum within 15 to 20 minutes. The digital LED panel lets you dial in exactly 58°C and hold it, which is the range where grease lifts cleanly without expanding aluminum tolerances on precision-fit parts. The 0 to 80°C range gives you that specificity.

Water disposal after a heavy shop session is not a small thing. The built-in brass drain valve on both models empties the tank without lifting or tipping. For a bench handling 10 to 15 units per day, that detail saves 20 minutes and one wet floor.

The SUS304 stainless steel tank resists the alkaline cleaning solutions most shops use, and the overheat protection system cuts power automatically if bath temperature exceeds the set threshold. I ran a full carburetor overhaul batch at 65°C for the first time and kept checking the display expecting a runaway temp. It held within 2 degrees the entire cycle.

Specs That Actually Matter on this Large industrial ultrasonic cleaner:

• 480W to 600W ultrasonic output (22L and 30L respectively) Higher acoustic density per liter means cavitation reaches the bottom of a 30mm fuel passage, not just the surface.
• 8 to 10 industrial-grade sandwich-type piezoelectric transducers Sandwich construction maintains consistent output over long run cycles; conventional transducers degrade faster under continuous shop use.
• 0 to 30 min adjustable timer with independent heating control Run ultrasonic and heat simultaneously or in sequence depending on the contamination type and material sensitivity.

The Large industrial ultrasonic cleaner, Built For Small Engine and Auto Restoration Shops:

A two-person carburetor rebuild shop processing vintage motorcycle carbs and small engine throttle bodies needs a tank large enough to batch-process 4 to 6 units at once without requeuing. The 30L footprint handles that load. The solid side handles make repositioning on a crowded bench possible without emptying the tank first, which matters at the end of a full day when you are already tired.

A 30-minute cycle at 65°C does what a 2-hour soak and manual scrub cannot: it clears the deposits you cannot see and cannot reach. Add the 30L model to your bench setup and process the backlog you have been putting off. And if you need more product, check our complet collection of ultrasonic cleaner machine.